index

Attach the Speaker to the Mount

Attach the speaker to the mount.

Attaching the Mount

Attach the mount to the surface.

Set speaker tap and/or light settings, located on the bottom of the device.

Adjust Tap & Light Settings

Connect the 70V, parallel wire run to the mount’s pigtail using the included silicon wire nuts.

Connections

Speaker & light

Quick Start

Mounts

Light and sound on one wire run.

Radiance

MB1

Tap the button for device specific instructions.

Subwoofer

Surface Mount

Pendant Mount

Tap the mount name for install directions.

Stake Mount

Wall Mount

All Radiance products use the same connection method, providing many configurable options.

The speaker cap is removable and provides a connection point for the light for further flexibilty.

Speakers and Lights

Adjust Speaker Tap Settings

Set the speaker’s tap settings, located on the bottom of the device.

Adjust Light Settings

Set the light settings, located on the bottom of the device.

Spot

Ring

Both

Attach the mount to the surface. Use the mount cap’s bubble level to make sure the mount is level on the wall.

Remove the cap and attach the speaker to the mount.

Hammer into place using the included cap with built-in bubble level.

Hammer into Place

Attach the Bracket

Attach the bracket to a junction box or flat to the ceiling.

Slide On the Plate and Lock Nut

Slide the lock nut and plate over the mount cable.

Pull the cable through the bracket so the mount hangs at the desired height.

Pull the Cable Through the Bracket

Loop the cable under the clip, then swing the latch closed to secure the mount’s height. Screw it into place by hand. Do not use a power drill.

Secure the Mount’s Cable

Slide the plate into place to cover the bracket and any extraneous cable. Use the lock nut to secure the plate.

Slide the Plate and Lock Nut into Place

Episode Radiance

Quick Start Guide

Connect the 70V wire run to the mount’s pigtail using the included silicon wire nuts.

Slide the plate and lock nut over the mount cable.

Attach the MB1 mount to the wall.

Attach the Mount

Place the MB1 into the mount, sideways, to hold it in place as you connect the wires.

Temporarily Place the MB1

Loosen the gland nuts to pull the wire through the water-tight cap beforce connecting any devices to the MB1.

Slide the Wires Through the MB1’s Cap

Connect the low-voltage lighting transformer to the Light Power input. Max lighting load is 300W.

Connect the Light Transformer

Connect the 70V DSP Amplifier

Connect the70V DSP amplifier to the Audio 70V input. Max audio load is 500W.

Connect the Radiance Wire Run

Connect the Radiance device wire run to the Output.

Slide the MB1 cap into place, tighten the gland nuts, then tighten the screws by hand.

Slide the Cap into Place

Secure the MB1 in the Mount

Rotate the MB1 so it stands vertically in the mount, then screw the MB1 into place by hand.

Place the Subwoofer

Bolt the subwoofer to a surface, or bury it, leaving two inches between the ground and grille.

Connect the Subwoofer

Connect the subwoofer to the amp’s 8Ω output. If using the Episode Hybrid amplifier, connect it to channel 1.