Verifying the IR codes using the Driver Wizard

Use the Edit Existing Driver menu option to verify your IR codes for the Control4 system. 

Note: Make sure the controller is connected to the device via IR, and that all necessary connections are made.

To verify driver IR codes using the Driver Wizard:

  1. Start Composer Pro and connect to a Director.
  1. From the Driver menu, select Edit Existing Driver.
  2. Select the driver type, such as VCR.
  3. Select the Codes section.
  4. Click next to advance to the screen for the first IR code listed.
  5. On the left side, use the scrollbar to select the code you want to test, and click Emit to verify the function of the specific IR code.
  6. Edit or recapture the codes as necessary.
  7. After you’ve edited the driver, click finish.
  8. Click next to save your changes. 

    9. IMPORTANT! If you edit any inputs or outputs of the driver after editing a driver, you must remove the driver from the project, add it to the project again from the Search tab, and make any necessary connections.

    Tip: To exit the Driver Wizard without saving your changes, click x at the top right of the screen.